:	Oct 18, 2007

: Observe due care when working near a hot exhaust system.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Disconnect the diesel particulate filter (DPF), differential pressure sensor electrical connector.

.

Release the DPF differential pressure sensor.   Release the clip.

.

Disconnect the DPF exhaust gas temperature sensor electrical connector.

.

: Make sure that the exhaust system is supported with a suitable transmission stand. Release the 6 exhaust hangers.

.

Remove the DPF rear heat shield.   Remove the 4 bolts.

.

:   Discard the gasket. With assistance, remove the muffler and tailpipe assembly.   Remove the 3 nuts.   Remove the bracket.

.

Remove the LH tail pipe.   Using the special tool, cut the exhaust pipe at the marked position.

.

Remove the RH tail pipe.   Using the special tool, cut the exhaust pipe at the marked position.

.

:   Do not tighten the clamp at this stage. Install the RH tail pipe to the muffler assembly.   Clean the components.   Install the clamp.

.

:   Do not tighten the clamp at this stage. Install the LH tail pipe to the muffler assembly.   Clean the components.   Install the clamp.

.

:   Install a new gasket. With assistance, install the muffler and tailpipe assembly.   Install the bracket.   Tighten the nuts to 48 Nm (35 lb.ft).   Secure the exhaust hangers.

.

Align both of the tail pipes and tighten the clamps to 48 Nm (35 lb.ft).

.

Install the DPF rear heat shield.   Tighten the bolts to 10 Nm (7 lb.ft).

.

Connect the DPF exhaust gas temperature sensor electrical connector.

.

Secure the DPF differential pressure sensor.

.

Connect the DPF differential pressure sensor electrical connector.